人造石打磨、晶面处理环节

填缝一定要采用柔性胶（或其它环氧树脂胶）调色，调色一定要非常接近石材颜色，填缝完毕后做整片区域石材打磨。注：云石胶弹性差，不建议用云石胶填缝，填缝深度不低于10mm；

打磨时不能偷工减少程序，从50#-6000#共7套磨片7个工序打磨后的石材表面无磨痕，无波浪纹，石材本身光泽度达65度以上，整片区域石材平整度1mm以下；

打磨完毕后做石材晶面处理，晶面处理必须要做三遍，光泽度达到85度以上。

The caulking must be made of flexible glue (or other epoxy resin glue) color, the color toning must be very close to the stone color, and the whole area of stone is polished after the completion of the caulking. Note: The elasticity of marble gum is poor, it is not recommended to use marble glue to fill the seam, and the depth of the caulk is not less than 10mm;

Grinding can not cut corners to reduce the program, from 50 # -6000 # a total of 7 sets of grinding discs 7 processes after grinding the stone surface without wear marks, no wavy patterns, the gloss of the stone itself is more than 65 degrees, the flatness of the entire area of stone is less than 1mm;

After polishing, the crystal surface treatment of the stone must be done three times, and the gloss reaches more than 85 degrees.